USE OF FINELY GROUND RECYCLED CONCRETE FOR IMPROVEMENT OF INTERFACIAL ADHESION IN FIBER-REINFORCED CEMENTITIOUS COMPOSITES

Authors

  • Radim Hlůžek
  • Jan Trejbal

DOI:

https://doi.org/10.14311/APP.2019.21.0005

Keywords:

recycled concrete, waste, adhesion, fiber reinforcement, fibrous composite

Abstract

This paper deals with an improvement and an assessment of a polymeric macro-fibers adhesion to the cement matrix. For this purpose, two approaches were employed – (i) roughening of fibers using a plasma treatment and (ii) an addition of finely ground recycled concrete (amount 30 wt. %) to the matrix ensuring the roughness of interfacial zones. Polyethylene terephthalate (PET) and polypropylene (PP) fibers, both ca. 0.3mm in a diameter, were used. These were surface roughened using a cold oxygen plasma treatment and then observed by means of the scanning electron microscopy. Consequently, pull-out tests of an individual fiber embedded 25mm in the matrix were performed, while the force needed for fiber pullout was recorded. Results have shown that plasma treated fibers reached on a better adhesion with the matrix by up to ca. 5% (PET) and 20% (PP), if compared to reference fibers. When recycled concrete was used, the adhesion increased further by about 5–10% for both fiber types.

Downloads

Published

2019-03-21

Issue

Vol. 21 (2019): CONTEMPORARY MATERIALS AND TECHNOLOGIES IN CIVIL ENGINEERING 2018

Section

Articles

License

Copyright notice

Authors who publish with this journal agree to the following terms:

1. Authors retain copyright and grant the journal the right of the first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., to post it to an institutional repository or to publish it in a book), with an acknowledgement of its initial publication in this journal.
3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges as well as earlier and greater citation of the published work (See The Effect of Open Access).