A COMPARISON OF THE TENSILE STRENGTH OF PLASTIC PARTS PRODUCED BY A FUSED DEPOSITION MODELING DEVICE

Authors

  • Juraj Beniak Slovak Univerzity of Technology in Bratislave Faculty of Mechanical Engineering
  • Peter Križan Slovak Univerzity of Technology in Bratislave Faculty of Mechanical Engineering
  • Miloš Matúš Slovak Univerzity of Technology in Bratislave Faculty of Mechanical Engineering

DOI:

https://doi.org/10.14311/AP.2015.55.0359

Keywords:

rapid Prototyping, FDM, Fused Deposition Modeling, 3D printer, Additive manufacturing

Abstract

Rapid Prototyping systems are nowadays increasingly used in many areas of industry, not only for producing design models but also for producing parts for final use. We need to know the properties of these parts. When we talk about the Fused Deposition Modeling (FDM) technique and FDM devices, there are many possible settings for devices and models which could influence the properties of a final part. In addition, devices based on the same principle may use different operational software for calculating the tool path, and this may have a major impact. The aim of this paper is to show the tensile strength value for parts produced from different materials on the Fused Deposition Modeling device when the horizontal orientation of the specimens is changed.

Downloads

Download data is not yet available.

Author Biographies

  • Juraj Beniak, Slovak Univerzity of Technology in Bratislave Faculty of Mechanical Engineering
    Institute of Manufacturing Systems, Environmental Technology and Quality Management; Assoc. Prof.; University Teacher; Researcher;
  • Peter Križan, Slovak Univerzity of Technology in Bratislave Faculty of Mechanical Engineering
    Institute of Manufacturing Systems, Environmental Technology and Quality Management; Assoc. Prof.; University Teacher; Researcher;
  • Miloš Matúš, Slovak Univerzity of Technology in Bratislave Faculty of Mechanical Engineering
    Institute of Manufacturing Systems, Environmental Technology and Quality Management; Researcher;

Downloads

Published

2015-12-31

Issue

Vol. 55 No. 6 (2015)

Section

Articles

License

Authors who publish with this journal agree to the following terms:

1. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.

2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.

3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).

4. ddd

How to Cite

Beniak, J., Križan, P., & Matúš, M. (2015). A COMPARISON OF THE TENSILE STRENGTH OF PLASTIC PARTS PRODUCED BY A FUSED DEPOSITION MODELING DEVICE. Acta Polytechnica, 55(6), 359-365. https://doi.org/10.14311/AP.2015.55.0359