Die Design for Near-Net Shape Forging

Authors

  • J. Čermák
  • G. Gráf

DOI:

https://doi.org/10.14311/436

Keywords:

flashless forging, die design, accommodation space, spring-operated device

Abstract

This paper discusses the use of conventional forging equipment for the manufacture of precise forging without flash. An analysis is presented of the factors influencing the forging process and the conditions for establishing this technique in a forge based on practical experience at the SKODA Auto forge. The main problem is usually the excess volume of billet material. Three basic forms of die design for overload protection are illustrated and discussed.

Downloads

Download data is not yet available.

Author Biographies

  • J. Čermák
  • G. Gráf

Downloads

Published

2003-01-03

Issue

Vol. 43 No. 3 (2003)

Section

Articles

License

Authors who publish with this journal agree to the following terms:

1. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.

2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.

3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).

4. ddd

How to Cite

Čermák, J., & Gráf, G. (2003). Die Design for Near-Net Shape Forging. Acta Polytechnica, 43(3). https://doi.org/10.14311/436