Influence of Surface on Quality of Conductive Adhesive Joints

Authors

  • P. Mach

DOI:

https://doi.org/10.14311/80

Abstract

. Special resistors with “zero” resistance were assembled using conductive adhesives on substrates with pads mentioned above. It was also found strong influence of material and surface quality of assembled components and conductive tracks on properties of the joints. The joints prepared on gold surface had lower resistance and lower nonlinearity in comparison with joints prepared on copper surface. It was also found that measurement of nonlinearity is a very useful method for investigation of quality of the joints.

Downloads

Author Biography

  • P. Mach

Published

2000-01-03

Issue

Vol. 40 No. 3 (2000)

Section

Articles

License

Authors who publish with this journal agree to the following terms:

1. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.

2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.

3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).

4. ddd

How to Cite

Mach, P. (2000). Influence of Surface on Quality of Conductive Adhesive Joints. Acta Polytechnica, 40(3). https://doi.org/10.14311/80