INFLUENCE OF PRINTING AND LOADING DIRECTION ON MECHANICAL RESPONSE IN 3D PRINTED MODELS OF HUMAN TRABECULAR BONE

Authors

  • Tomáš Doktor Intitute of Theoretical and Applied Mechanics of the CAS, Prosecká 76, 190 00 Prague 9, Czech republic
  • Ivana Kumpová Intitute of Theoretical and Applied Mechanics of the CAS, Prosecká 76, 190 00 Prague 9, Czech republic
  • Sebastian Wroński AGH University of Science and Technology, aleja Adama Mickiewicza 30, 30-059 Kraków, Poland
  • Maciej Śniechowski AGH University of Science and Technology, aleja Adama Mickiewicza 30, 30-059 Kraków, Poland
  • Jacek Tarasiuk AGH University of Science and Technology, aleja Adama Mickiewicza 30, 30-059 Kraków, Poland
  • Giancarlo Forte International Clinical Research Center of St. Anne’s University Hospital Brno, Pekarská 53, 656 91 Brno, Czech republic
  • Daniel Kytýř Intitute of Theoretical and Applied Mechanics of the CAS, Prosecká 76, 190 00 Prague 9, Czech republic

DOI:

https://doi.org/10.14311/APP.2018.18.0024

Keywords:

additive manufacturing, tomography, deformation response

Abstract

The paper deals with investigation on directional variations of mechanical response in 3D printed models of human trabecular bone. Sample of trabecular bone tissue was resected from human donor and 3D model was obtained by X-ray computed tomography. Then a series of cubical samples was prepared by additive manufacturing technique and tested by uniaxial compression loading mode. Mechanical response was compared in nine different combinations of direction of 3D printing and loading direction. The results show neglectible influence on the deformation response in elastic region (stiffness) and significant changes of the behaviour in plastic region (stress and strain at yield point, strain at full collapse).

Downloads

Published

2018-10-23

Issue

Vol. 18 (2018): 16th YOUTH SYMPOSIUM ON EXPERIMENTAL SOLID MECHANICS

Section

Articles

License

Copyright notice

Authors who publish with this journal agree to the following terms:

1. Authors retain copyright and grant the journal the right of the first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., to post it to an institutional repository or to publish it in a book), with an acknowledgement of its initial publication in this journal.
3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges as well as earlier and greater citation of the published work (See The Effect of Open Access).